Ratio Electric-Handleiding EV3701

6 OPERATION The Ratio Electric Mode 2 Charge Cable offers maximum security when charging your EV from a standard Schuko or CEE outlet. Just plug the wall plug into the earth-grounded 230V wall socket. Always plug in the wall socket first. Now the Power LED will light up. The 6A Ready/Charge LED will start blinking. You can change the charge current by pressing the button. The chosen charge current LED starts blinking. Plug the vehicle connector firmly into the vehicle’s charge port. After a few seconds Ready/Charge LED stops blinking and will be lighting continuously. Now the cable is charging at the selected current. During the charging it’s not possible to change the charge current anymore. When disconnecting the charge cable, always remove the vehicle connector first then remove the plug from the wall socket. Note: For charge cables with a Schuko wall plug you can choose between 6A, 10A and 13A. For charge cables with a CEE wall plug you can choose between 6A, 10A and 16A. ERROR NOTIFICATION In case of earth failure, the Fault LED lights up red immediately after the wall plug is plugged into the wall socket. To avoid the error the wall socket needs always to be earth-grounded. The Fault LED can also light up red during the charging. In this case please remove the vehicle connector from the vehicle and wait a few seconds. Choose the charge current and plug the vehicle connector once more into the charge port of the car. If the Fault LED lights up again remove the vehicle connector and the wall plug. Try again to connect the Charge Cable correctly and charge the vehicle. If the Mobi Box continues to display the error during the charging, please contact Ratio Electric for support.